ASSEMBLAGE OF THE CLAWED NAIL
NOTE! IS NOT NECESSARY TO PRE-DRILL HOLES IN THE FOOTWEAR
1. Place the head of the stud in the head of the installation tool
2. Place the tip of the screwed end of the stud on the surface of the footwear
3. Applying steady force at right angles to the tyre screw very slowly into place.
4. Screw in manual mode with the handle provided
In this case the clawed nail (to rapid assemblage, detachable, adjustable) it doesn’t serve not to slip on terrestrial clammy, but to the exact contrary, a sort of correct adherence and fluency of the supermotard boot on the asphalt. It avoids the consumption of the sole; it doesn’t absolutely ruin the asphalt of the footsteps.
WAY OF RECOMMENDED USE: Run in for some turn the boot to have the correct inclination of the sole, therefore to climb on the nails. The number and the position it will be definite from you to have the correct equilibrium among I don’t consume of the sole and sensibility of the foot. The boot will be personalized by you looking for the good compromise.
RECOMMENDED ASSEMBLAGE: Two nails on the heel, better if to the extremities. Three nails on the sole inserted in equidistant way. The nail must be inserts to thread of the sole.
A wrapping contains 10 nails anti wear and tear the utensil for the application and custody in nylon. The set of exchange contains 10 nails anti wear and tear.
TESTED AND APPROVED BY THE BEST PILOTS OF THE ITALIAN AND WORLD CHAMPIONSHIP
